Yo Motherboard

Experiencing BSOD After Replacing SSD – What Could Be the Issue?

August 19, 2025 4 answers
Asked by TechWhiz42
Hey everyone! I've been using my PC for about 6 years without any major issues, but recently, it started suffering from severe stutters that often ended with a BSOD or a total freeze. At one point, it wouldn't even recognize the SSD in the BIOS unless I waited about 15-20 minutes before restarting. I figured the SSD was failing, so I replaced it and installed Windows on a new one. For a while, everything seemed to be back to normal. However, just recently, I encountered another couple of BSODs, one of which flashed the KERNEL_DATA_INPAGE_ERROR code, and once again, the BIOS couldn't detect the SSD. I'm puzzled and worried that there might be some other underlying issues. Could my RAM also be failing, or might I have just gotten unlucky with a faulty new SSD? I'm hoping to get some insights and advice to avoid this ship of Theseus dilemma with my components!
BSOD Hardware kernel error PC troubleshooting RAM issues ssd

Answers

GamerGuru88
You should definitely check for dump files to get a clearer picture of what's causing the BSODs. If you can access Windows normally or via Safe Mode, look for C:WindowsMinidump. If there are any dump files there, zip them up and upload them to a file-sharing site. The more dump files you have, the better for analysis! Also, consider configuring your system for small memory dumps if you don't have many files to start with.
Reply to this answer
MotherboardMaverick
That KERNEL_DATA_INPAGE_ERROR really raises some alarms about your storage setup. If you’re using an M.2 slot, the problem could be a bad motherboard slot. If it’s SATA, it might be a cable issue – or worse, a faulty SATA controller on the motherboard. You might want to look into ways to test the motherboard or try a different SATA cable to see how it behaves.
Reply to this answer
RAMRanger99
Testing your RAM is a good call. Memtest86 is pretty standard for that, or you could use Hiren's Boot CD, which has a bunch of testing tools for RAM, drives, and other components. It's worth running those tests to rule out RAM issues.
Reply to this answer
ComponentCheck32
Looks like the dump file you mentioned points to problems with your Samsung SSD 870 EVO. If that’s the new SSD, check if you have any other SATA cables lying around. Bad cables can definitely cause issues, especially since the problem is sporadic, and sometimes can lead to the drive not being recognized.
Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions