My Proxmox host has 192.168.0.196/24 on vmbr0, with the wired interface attached to the bridge and showing UP. The Wi-Fi interface is down. The switch port has a blinking light, but the host can't ping the internet and another local device can't ping it. Where should I start?
Proxmox has an IP address but can't ping anything. What should I check?
Answers
Start at the local link, not DNS. A failed ping to a numeric internet address doesn't depend on DNS, and the failed local ping points to something closer to the host.
From the Proxmox console, check ip route and try pinging your router's local IP. Then check ip neigh to see whether the router's address resolves to a MAC address. If it stays incomplete or failed, check the cable, switch port, VLAN settings and whether the router really is on the same subnet. A blinking switch light shows activity, but doesn't prove traffic is reaching the right network.
Reply to this answer
The IP being on vmbr0 rather than the physical Ethernet interface is normal for a Proxmox bridge. Check /etc/network/interfaces and make sure bridge-ports names the actual wired interface, with the address and gateway configured on vmbr0.
Run ip -br link and bridge link to compare the interface names with the configuration. The bridge and port showing UP is useful, but it doesn't rule out a wrong switch VLAN or other link problem. Keep console access available if you change the network config, since a mistake can cut off remote access.
Reply to this answer
A DHCP reservation and a static address on the host are different things. If Proxmox is statically configured, the router doesn't assign that address just because a reservation exists. Make sure the address isn't in use elsewhere and that the subnet mask and gateway match the LAN.
If you're using DHCP instead, check that the reservation matches the wired interface's MAC, not the Wi-Fi MAC. Removing a reservation won't by itself fix a bad bridge or cable.
Reply to this answer
The Wi-Fi interface being down is fine if you're using Ethernet. A normal VM bridge over Wi-Fi can be awkward because many wireless setups don't support forwarding traffic for multiple MAC addresses. There's no need to reinstall Proxmox or disable Wi-Fi just to troubleshoot this wired connection.
Reply to this answer
If the host can reach the router but not the internet, check the default gateway in ip route and test another numeric address. If local devices still can't ping the host even though it can reach the router, look at firewall rules and any client isolation on the network. Ping can be blocked without all connectivity being broken.
Reply to this answer
Add your answer
Answers are reviewed before publication.
_k56!plumratchet.3:
Also check that the other computer is actually on the same subnet and not isolated on a guest network before using its failed ping as a test.