What would you replace a server room tower UPS with?

November 16, 2026 4 answers
Asked by 7a!melonratchet_518

We have two server rooms with unsupported tower UPS units providing 120 V and 240 V single-phase power. The current load is about 5 kW, and we're looking for around 30 minutes of backup so we can shut down if the building generator fails to start.

What equipment and support options would you look at in southwest Michigan?

Answers

_q91!luggagebolt.4

I'd put Eaton on the shortlist and ask for a quote that includes the batteries and network management card, not just the UPS cabinet. APC and Vertiv's Liebert line are also worth comparing, though people have pretty different opinions about their equipment and support.

Ask each supplier about parts availability, battery replacement, preventive maintenance and response times in your area. Since the existing units are being replaced because parts aren't available, the service plan matters as much as the brand.

Reply to this answer
6e+drumstencil_293

This sounds like a job for a UPS contractor to measure and specify, rather than picking a model from a catalog. Get bids for each room and spell out whether that 5 kW figure is per room or combined. Ask for a runtime estimate at the actual load, including the battery configuration needed for 30 minutes.

Also give them the shutdown sequence and generator arrangement. The backup window needs to cover the time to detect a generator failure and shut equipment down, not just the shutdown commands themselves.

_k45!switchpocket.7:

I'd ask for the estimated runtime with aging batteries too, and what maintenance schedule is needed to keep that target realistic.

Reply to this answer
_g52!spoolruler.4

Clarify the electrical setup before comparing units. Does each UPS need to supply both 120 V and 240 V, and what are its input voltage and circuit ratings? Have the installer check the existing distribution and loads rather than assuming a replacement with the same label will fit.

Reply to this answer
a.384~drainpuzzle

Check the monitoring options on the exact model you're quoted. Some units need a separate network card, and a built-in port may only be for console access. If local SNMP monitoring matters, confirm how it works and whether any subscription is required before ordering.

w.293+hingequill:

APC's SmartConnect options and its regular network cards aren't necessarily the same thing. Check the specific hardware and terms instead of assuming the whole range works alike.

Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions