What's the deal with the Micron SSD slowdown after 65,535 hours?

November 17, 2026 3 answers
Asked by _z68!marblewicket.2

Dell has warned that some Micron SSDs can slow down after 65,535 power-on hours. Is that continuous uptime, and what should admins check?

Answers

Virelno+4c

It's accumulated power-on time, not time since the last reboot. 65,535 hours is about seven and a half years with the drive powered continuously, but it can also accumulate over a longer calendar period.

The number is the maximum value of an unsigned 16-bit counter. Dell describes an internal firmware limitation involving a counter used for workload log entries. The advisory is about performance degradation, so don't assume it means the drives suddenly fail at that point.

Nervalo.5k:

So rebooting the server doesn't reset the drive's lifetime power-on hours. Checking that value on the drive is more useful than checking the server's uptime.

Reply to this answer
b.6+trundel

Start with an inventory of drive model numbers, firmware versions and power-on hours. Compare the actual drives against Dell's affected-model list rather than assuming every drive in a notified server is affected.

Check the advisory for firmware availability and instructions before planning an update. The discussion indicated a fix wasn't available yet for at least some affected drives, so don't assume there's already a package for every model.

_z68!marblewicket.2:

Good point about checking the drives themselves. A notification for a server doesn't necessarily tell me which installed drives match the advisory.

Reply to this answer
_w62~pixelgrommet.3

There have been other SSD firmware bugs tied to power-on hours, including some where drives failed to initialize after a power cycle. That's a useful reason to take the warning seriously, but it's a different failure mode from the slowdown described here.

If a system is already slow, check whether its drives and hours match the advisory before blaming the controller or assuming this is the cause. A cold power cycle was reported to temporarily relieve symptoms in one case, but that's not a firmware fix.

Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions