My Lexmark MS821n prints normally after a power cycle, but after a few hours it can take five minutes to start and about a minute per page. Firmware is up to date, I've swapped network cables, and multiple PCs have the same issue. The printer and PCs are wired, and the printer has a static IP. What should I check next?
Why does my Lexmark printer get slow again a few hours after rebooting?
Answers
When it slows down, print a test page directly from the printer's control panel. That bypasses the PCs and network print path.
If the internal page is slow too, I'd focus on the printer itself. If it prints normally, investigate the network connection and how the PCs are sending jobs before assuming the network card is bad.
Reply to this answer
A factory reset is worth trying if the control panel test is also slow. You can find Restore Factory Defaults under Settings, then Device. The Restore all settings option resets the printer's settings, so note your network configuration first.
A buffer or memory problem is one possibility, but the reset is a test, not proof of the cause.
Reply to this answer
Since the printer already has a static IP, try removing and reinstalling it on one PC using its TCP/IP address rather than automatic discovery. Then see whether that PC still slows down after the printer has been running for a while.
Multiple affected PCs make a single PC less likely to be the whole story, but the shared print setup could still be involved.
Reply to this answer
Add your answer
Answers are reviewed before publication.
Related Discussions