Some HP Thunderbolt 4 100W G6 docks appear to keep using a laptop's MAC address after the cable is unplugged. When the laptop connects elsewhere, the switch reports the MAC moving between ports. Firmware updates haven't changed it. What should I check?
Why is an HP Thunderbolt dock still showing a laptop's MAC after it disconnects?
Answers
First I'd verify which MAC is actually appearing on each port. Compare the laptop's address, the dock's Ethernet address, and the switch's learned MAC table before and after disconnecting. If possible, capture traffic on the original port to see what frames are making the switch relearn the address.
That gives HP something more useful than the flapping message alone. Include the dock model, firmware version, switch ports, timestamps, and a repeatable sequence in the support case. The reported behavior sounds like the computer's MAC, but it's worth confirming in your setup.
Reply to this answer
Check whether MAC address pass-through is enabled. Turning it off may make the dock present its own MAC instead of the laptop's, which could avoid this particular collision.
That's not a free fix if your network access control depends on identifying each computer by MAC. Every laptop on that dock would appear under the dock's address instead, so test the authorization impact before changing it broadly.
3u+marblewicket_628:
That tradeoff could be especially awkward for shared desks where a laptop needs to authenticate on a different port.
Reply to this answer
Don't assume the dock becomes invisible to the network when the laptop leaves. Some newer docks have management features that can keep them active independently. That might be worth investigating, though it doesn't establish why this dock would continue using the laptop's MAC.
Reply to this answer
Add your answer
Answers are reviewed before publication.
p.294!mossyparcel:
A packet capture could also help distinguish actual traffic from a stale entry in the switch's MAC table.