PC still won't power on after replacing the PSU and motherboard. What else should I check?

November 18, 2026 5 answers
Asked by v.629+claspmaraca

My desktop shut off suddenly and now shows no lights or fan activity. A replacement power supply and motherboard made no difference, and I hear a quiet click when I press the power button.

I've checked the usual power connections and tried another outlet. Can a faulty component stop the whole system from showing any signs of life?

Answers

Zeltravo-8p

Yes, a short or a faulty component can cause the PSU's protection to shut it down immediately. The click could be related, but it doesn't identify the cause by itself.

Unplug the system and strip it down to the motherboard, CPU and cooler, one RAM stick, and the required power connections. Disconnect drives, peripherals, front panel accessories, and the graphics card if the CPU has integrated graphics. Then try powering it on. Add parts back one at a time if it responds.

Check for a misplaced motherboard standoff or anything else touching the underside of the board too. Testing the board outside the case on a nonconductive surface can help rule that out.

v.629+claspmaraca:

Removing the graphics card let it start. I'll investigate the card and its power connections before putting it back.

Nexravi+8d:

That narrows it down, though it doesn't prove the card itself is bad. The card's power cable or connection could also be involved.

Reply to this answer
3h+fablewicket_592

Double-check the modular PSU cables before another test. Use only cables supplied with the replacement PSU or confirmed compatible by its manufacturer. The PSU-side pinouts aren't standardized, even when plugs fit.

If any old modular cable was reused, unplug the PC and replace it before powering on again. Mixed cables can damage components.

v.629+claspmaraca:

I swapped all the modular cables when I installed the new PSU, so none of the old ones are still connected.

Reply to this answer
5x+ferrulepocket_693

Try bypassing the case power button. Disconnect its connector from the motherboard and briefly bridge the two power switch pins, using the board manual to identify them. That takes the button and its cable out of the test.

v.629+claspmaraca:

I tried the motherboard power pins too, with no response.

Reply to this answer
_g71!plaxeno.4

For a stripped-down test, try one RAM stick at a time in the slot recommended by the motherboard manual. Bad RAM can prevent a system from completing startup, although no lights or fan activity at all may point elsewhere.

Reply to this answer
_p82!gromneli.6

A replacement PSU can be faulty too, though that isn't the first thing I'd assume. A PSU tester can provide another check. Watch for any motherboard status LEDs during testing, but don't treat a lack of LEDs as proof of a particular failure.

Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions