Is there an easier way to configure a Cisco switch without a CCNA?

You might want to check the manual for your switch first. It usually contains all the details you need. While the Web UI can be used, it’s best accessed from a secure network. Learning to use the CLI is super helpful, too—it’s faster and can make things easier for automation. Plus, it really helps you understand the configuration better.

You should be able to use the web UI by navigating to the switch’s IP address. I'm not sure why you'd need a CCNA for this. In fact, if you're comfortable with the Web UI, you could manage most tasks from there!

For upgrading the firmware, assuming you have access to the privileged CLI, you can follow these steps:

1. `copy http://objstore.example.edu/cisco/c1000-151.bin flash:`
2. `boot flash:c1000-151.bin`

If you want to factory reset it, just use `erase startup-config`. Don’t forget to reboot with `reload` and check your version with `show version` after that.

Honestly, if you’re struggling with basic tasks like these, you might want to reconsider working on switches. There’s a wealth of information available online to guide you through these processes.